Description
Lenz DCC LH01 ~ Throttle Digital Plus XpressNet Hand Controller 21010
Manual controls are the typical input devices of the system, because manual operation is still the strongest area of application for digital control.
* The handhelds can be unplugged from the XpressNet during operation if the corresponding LA152 XpressNet sockets are attached.
* The last selected locomotive address is immediately shown on the display when it is plugged into the XpressNet again
simultaneous use of up to 31 devices.
* No restrictions on access to the locomotives, every hand controller on the XpressNet has equal rights
all handhelds have the switch option.
Manual Controller LH01
The LH01 is a device for the XpressNet ® , enjoy all the advantages of this fast system bus for the digital plus system. So you can of course connect and disconnect the LH01 during operation, the last operated locomotive remains saved and can be controlled again immediately.
In addition, the XpressNet works bi-directionally: You can also call up information from the control system: if you select a new locomotive, for example, its current speed, direction of travel and the status of the functions are adopted immediately. You can continue seamlessly.
The LH01 at a glance:
Finely graduated, precise rotary control.
Choice of club mode.
9,999 addresses for digital locomotives.
Address “0” for an analog locomotive * Attention! Important NOTE!
Stack for quick selection of 12 freely selectable locomotive addresses.
In conjunction with the LZV100 / LZV200 central unit, up to 29 functions (F0 to F28) can be addressed in corresponding locomotive receivers.
Each decoder function can be set as a permanent or momentary function.
Programming the parameters of locomotive decoders on a separate programming track and on the main track (PoM).
Switching options for up to 999 turnouts, signals, magnetic items and other accessories.
The Club Mode:
The Club modes make driving pleasure with the LH01 even easier and “less dangerous”. There are three modes:
Club mode 2: Only the set locomotive can be controlled, the functions assigned to the function keys A, B and C can be switched. All other operating options of the LH01 are blocked.
Club mode 1: Only the set locomotive can be controlled, the functions assigned to the function keys A, B and C can be switched, switches and signals can be switched. All other operating options of the LH01 are blocked.
In mode 0 (factory setting) the LH01 can be used without restriction.
Modes 1 and 2 are password-protected, so the LH01 cannot be easily reset to mode 0. In this way, even inexperienced teammates or several “train drivers” in the club can be entrusted with one train each.
The LH01 can be used on the well-known Digital plus control panels from version 3.6 (LZ100, LZV100 and LZV200 ).
